How To Install Trafficmaster Allure Resilient Plank Flooring

How to Install Trafficmaster Allure Resilient Plank Flooring

Installing Trafficmaster Allure resilient plank flooring is a relatively simple and straightforward process that can be completed by most DIY enthusiasts. With a little planning and preparation, you can have a beautiful new floor in no time.

Tools and Materials You'll Need

* Trafficmaster Allure resilient plank flooring * Measuring tape * Pencil * Utility knife * Tapping block * Pull bar * Safety glasses * Knee pads * Gloves

Step 1: Prepare the Subfloor

The first step is to prepare the subfloor by removing any existing flooring, baseboards, and quarter-round. The subfloor should be level, flat, and clean. If there are any uneven areas, you can use a self-leveling compound to smooth them out.

Step 2: Measure and Cut the Planks

Once the subfloor is prepared, you can start measuring and cutting the planks. Measure the length of the room and cut the planks to fit. You will need to leave a small gap between the planks and the walls to allow for expansion and contraction.

Step 3: Install the First Row

Start installing the first row of planks along the longest wall in the room. Tap the planks together using a tapping block and a hammer. Make sure that the planks are flush with each other and that there are no gaps.

Step 4: Continue Installing the Planks

Continue installing the planks, row by row, until you reach the end of the room. Be sure to stagger the joints between the rows to create a more durable floor.

Step 5: Install the Baseboards and Quarter-Round

Once all of the planks are installed, you can install the baseboards and quarter-round. This will help to hide the expansion gap and give the floor a finished look.

Tips for Installing Trafficmaster Allure Resilient Plank Flooring

* Use a sharp utility knife to cut the planks. A dull knife can cause the planks to tear. * Tap the planks together firmly, but not too hard. If you tap the planks too hard, you can damage them. * Leave a small gap between the planks and the walls to allow for expansion and contraction. * Stagger the joints between the rows to create a more durable floor. * Install the baseboards and quarter-round to hide the expansion gap and give the floor a finished look.