Allure Gripstrip Resilient Tile Flooring Installation Guide

Installing Allure Gripstrip resilient tile flooring is a relatively straightforward process that can be completed in a few hours. However, it is important to follow the manufacturer's instructions carefully to ensure a successful installation.

The first step is to prepare the subfloor. The subfloor must be clean, dry, and level. Any unevenness in the subfloor can cause the tiles to buckle or crack. If the subfloor is not level, you may need to level it using a self-leveling compound.

Once the subfloor is prepared, you can begin installing the tiles. Start by laying out a few tiles in a dry fit to determine the best layout. Once you have determined the layout, you can begin gluing the tiles down. Use a high-quality adhesive that is specifically designed for resilient tile flooring.

When gluing down the tiles, be sure to apply the adhesive evenly to the back of the tile. Do not over-apply the adhesive, as this can cause the tiles to buckle. Once the adhesive has been applied, press the tile firmly into place. Use a rubber mallet to tap the tile into place if necessary.

Continue gluing down the tiles until the entire floor is covered. Once the tiles are glued down, you can trim any excess tile around the edges of the room. You can use a utility knife to score the tile and then snap it off.

Once the tiles are trimmed, you can install the baseboards. The baseboards will help to hide the edges of the tiles and give the room a finished look. You can use a nail gun to install the baseboards.

Installing Allure Gripstrip resilient tile flooring is a relatively simple process that can be completed in a few hours. By following the manufacturer's instructions carefully, you can ensure a successful installation.

Additional Tips

Be sure to wear gloves and safety glasses when installing resilient tile flooring.
Do not install resilient tile flooring in areas that are exposed to moisture.
If you are installing resilient tile flooring in a large room, it is best to work with a partner.
Allow the adhesive to dry completely before walking on the floor.
Clean the floor regularly with a mild detergent.